Before starting the following steps, ensure you have completed the printer's network configuration using the “Flashlabel Pro” APP.
Refer to this link for network setup: Knaon Y486AP Wi-Fi printing setup via Flashlabel Pro (Android/iOS)
Step 1: Install the KNAON Y486AP Printer
Connect and install the printer via a Network connection.
Step 2: Access the Printer’s Web Management Page
-
Open any web browser on your computer (e.g., Chrome, Edge, Firefox).
-
Enter the printer’s unique URL in the browser’s address bar.
How to get the URL:
-
Locate the purple button on the top of the printer.
-
Press and hold the purple button until you hear two beeps, then release it.
-
The full URL will be shown on the printed self-test page.
First-time access note:
If your browser displays a security prompt (e.g., "Your connection is not private"):-
Click the "Advanced" option.
-
Select the option to proceed to the page (the button label may vary by browser).
-
Step 3: Log In to the Web Management Interface
-
On the login page, enter the password.
-
Default password for KNAON Y486AP:
12345678 -
Click the "Login" button.
Step 4: Navigate to the Setup Menu
In the web management interface, find and click the "Setup Menu" option.
Step 5: Select "Virtual Printer" in the Component Section
-
On the "Setup Menu" page, locate the "Component" section.
-
Find and select the "Virtual Printer" option.
- After selecting "Virtual Printer", click the "Accept or setup" button to access the parameter configuration interface.
Step 6: Set Print Density and Speed
In the parameter configuration interface, configure the following settings:
-
Density: Controls how dark/light the printed content is.
-
Speed: Controls how fast the printer processes and outputs documents.
Select your preferred options from the available drop-down menus or controls.
After confirming your selections, click the "Accept" button to save the changes. The new settings will take effect immediately.